We found that Lrp5/6 also has an important role in glucagon-induced b-catenin signaling

shed thrice with deionized water and were gradually dehydrated with acetone gradient between 30 and 90% and finally suspended in 100% acetone; small pieces of fibers were air dried and 2199952 placed on the stubs, mounted with silver tape, and sputter coated with gold using fine coat and examined at 10 KV. Results and Discussion Optimization of Deinking of ONP Pulp with Xylanase and Laccase Using Response Surface Methodology Central composite design with three factors – pH, enzyme dose and incubation time at five levels was employed to investigate the first and higher order main effects of each factor and interaction amongst them for deinking of ONP pulp using xylanase and laccase enzymes. With xylanase, maximum brightness of 53.560.4% ISO at temperature 65uC, pH 9.0, enzyme dose 15 U/g odp, 150 rpm and incubation time 3 h was obtained; With laccase, maximum brightness of 54.960.5% ISO at temperature 55uC, pH 8.0, enzyme dose 50 U/g odp, 150 rpm and incubation time 4 h was obtained. This is in accordance with previous studies which showed a brightness increase of 3.22 and 1.7% and 19.4 and 7.8% after xylanase and laccase-mediator pretreatments respectively. ANOVA results of the data disclosed that the models, all independent variables, interactions among pH, enzyme dose as well as time were significant and the lack of fit was not 26507655 Physical and Chemical Characterization of Hand Sheets All physical, chemical and residual chlorine measurements were carried out by following the TAPPI standard methods for brightness and whiteness, kappa number, tear factor, burst factor, breaking length and viscosity. The effective residual ink concentration was measured with the Elrepho ERIC tester using Lorentzen and Wettre software. 4 Eco-Friendly Deinking of Old Newsprint Parameters Empirical crystalline index Apparent crystal size Cellulose crystallinity index doi:10.1371/journal.pone.0072346.t003 P-C 29.16 0.78 1.16 P-X-L-C 65.47 1.35 1.28 significant. The 3D graphs showed that brightness of deinked pulp was affected by the variation of two factors at a time keeping the third at optimal condition in both xylanase and laccase pretreatments and maximum brightness was obtained when all three factors were at their optimal levels. Chemical deinking causes removal of ink particles from pulp fiber only whereas laccase enzyme may have caused either decolourization only or both decolourization and dislodging of ink particles. This was further supported by the fact that on comparing the absorbance scans of effluents to detect the release of colored compounds, chemically treated pulp effluent showed high absorbance whereas laccase treated and untreated pulp effluents were colourless. This is the first report on deinking of ONP pulp with a bacterial laccase without the need of a mediator, thus making the process cost effective and eliminating mediator-linked enzyme toxicity problems. Furthermore, no deinking effect was observed with laccase in the presence of laccase inhibitor MedChemExpress Debio1347 sodium azide which confirmed the role of laccase in deinking. Sequential Deinking of ONP Pulp with Xylanase and Laccase The present work demonstrated that an improved level of deinking was achieved by using xylanase and laccase sequentially as compared to xylanase or laccase alone. Pretreatment of ONP pulp with xylanase, followed by laccase, obtained a brightness of 59.660.8% ISO which was 8.5, 11.4 and 21.6% higher than that of the P-L-C, P-X-C and untreated pulp. ERIC for P-XL-C deinked pulp was 18